Ubik Batch Server Remote Debugging
From UbikWiki
(Difference between revisions)
(→Setup Batch Server) |
(→Setup Batch Server) |
||
Line 24: |
Line 24: | ||
** Edit <INSTALL_FOLDER>/bin/console.bat | ** Edit <INSTALL_FOLDER>/bin/console.bat | ||
- | * 4) Connect to Batch Server using JConsole: | + | * 4) This line will appear in shell: |
+ | ** Listening for transport dt_socket at address: 5006 | ||
+ | |||
+ | * 5) Connect to Batch Server using JConsole: | ||
** Click on <JDK_HOME>\bin\jconsole.exe | ** Click on <JDK_HOME>\bin\jconsole.exe | ||
<center>[[Image:UBS_jconsole.png]]</center> | <center>[[Image:UBS_jconsole.png]]</center> |
Revision as of 15:01, 18 September 2012
Contents |
Remote Debugging
What is it
Remote debugging enables simple debugging of Batches from inside Eclipse Environment.
You will typically:
- Start the Batch Server with socket debug
- Configure your Eclipse to Remote Debug one BAR project
Setup Batch Server
- 1) Run Batch Server Installer, see []
- 2) Add DEBUGGING options to Batch Server command line:
- Edit <INSTALL_FOLDER>/bin/setenv.bat
- Find JAVA_OPTS
- Add at end :
-Xdebug -Xrunjdwp:transport=dt_socket,server=y,suspend=n,address=5006
- In this example, we put 5006 as debug port (ensure this port is not used)
- 3) Start Batch Server using:
- Edit <INSTALL_FOLDER>/bin/console.bat
- 4) This line will appear in shell:
- Listening for transport dt_socket at address: 5006
- 5) Connect to Batch Server using JConsole:
- Click on <JDK_HOME>\bin\jconsole.exe
- Enter in remote field, the URL that is contained in file:
- <INSTALL_FOLDER>/config/jmx-service-url.txt
- Example:
- service:jmx:rmi://GIHQD134:5002/jndi/rmi://GIHQD134:5001/UBS600
- Enter in remote field, the URL that is contained in file:
- Enter:
- username : dev
- password : dev
- Enter:
Setup Eclipse Launcher
In Eclipse Select Debug>Debug Configurations:
Fill in:
- Project (your BAR project)
- Host : localhost
- Port : The port you configured in Batch Server in JAVA_OPTS, 5006 in our example:
That's it
Now here is what you get:
- You can put DEBUGGING points in your project code to debug your batch